Originals
13
1
Originals
The machine can detect the following original sizes placed on the exposure glass:
If the machine cannot detect the original sizes properly, select the area to copy
with the {Edge Erase} key. ⇒ P.40 “Edge Erase”. The machine may not detect the
original size properly when:
•Originals contain index tabs.
•Originals are OHP transparencies or are translucent.
•Originals are dark.
•Originals contain solid images.
•Originals are of sizes other than those listed above.
If you do not lift the platen cover more than 30cm, 12" when you place another
original, the machine might not detect the next original size correctly.
The maximum original size you can place on the exposure glass is 304.8 ×
432mm, 12" × 17".
If you use originals that have bold letters or solid images at the leading edges,
you might get prints with dirty edges. In this case, place the original face down
with the widest margin toward the paper delivery tray or raise the printing
speed.
Place originals after correction fluid and ink have completely dried. Not taking
this precaution could mark the exposure glass and cause marks to be printed.
In most situations, place originals as shown below.
When the original is placed in a direction that differs from the print paper, the
machine automatically rotates the original image by 90° to match the print paper
direction.
The first 8mm, 0.32", of the leading edge and the last 2mm, 0.08", of the trailing
edge cannot be printed. Make sure the leading edge margin is at least 8mm,
0.32", and the trailing edge margin is at least 2mm, 0.08".
Metric version A3L, B4L, A4KL, B5KL
Inch version 11" × 17"L, 81/2" × 14"L, 81/2" × 11"KL
R
R
R
R
ZDZX030E