RIDGID 690 Tool and Work Area Set-Up, Operating Instructions For Threading with 11-R Die Heads

No. 690 Portable Power Drive

Tool and Work Area Set-Up

WARNING

To prevent serious injury, proper set-up of the Power Drive and work area is required. The fol- lowing procedures should be followed to ensure proper set-up of the tool.

1.Locate a work area that has the following:

•Adequate lighting

•No flammable liquids, vapors or dust that may ignite.

•Clear path to the electrical outlet that does not contain any sources of heat or oil, sharp edges or moving parts that may damage electrical cord.

•Dry place for operator. Do not use the Power Drive while standing in water.

•Level ground for tristand vise and pipe stands.

2.Clean up the work area prior to setting up any equip- ment. Always wipe up any oil that may have splashed or dripped from the oiler to prevent slips and falls.

3.Plug the Power Drive into the electrical outlet making sure to position the power cord along the clear path selected earlier. If the power cord does not reach the outlet, use an extension cord in good condition.

WARNING To avoid electrical shock and electrical fires, never use an extension cord that is damaged or does not meet the following requirements:

•The cord is rated as “W” or “W-A” if being used outdoors.

•The cord has sufficient wire thickness (14 AWG below 25′/12 AWG 25′ - 50′). If the wire thick- ness is too small, the cord may overheat, melting the cord’s insulation or causing nearby objects to ignite.

WARNING To reduce risk of electrical shock, keep all electrical connections dry and off the ground. Do not touch plug with wet hands.

4.Check the Power Drive to insure it is operating prop- erly.

•Depress the paddle switch and safety lock making sure the Power Drive stops when releasing the switch.

•Depress and hold the switch. Inspect the moving parts for misalignment, binding, odd noises or any other unusual conditions that may affect the safe and normal operation of the tool. If such condi- tions are present, have the Power Drive serviced.

•Flip the directional switch to the opposite direction. Check that that Power Drive rotates in an opposite direction.

CAUTION Change position of the directional switch only when motor is switched OFF.

Operating Instructions For Threading with 11-R Die Heads

WARNING

Do not wear gloves or loose clothing when operating Power Drive. Keep sleeves and jackets buttoned.

Do not use this Power Drive if switches are bro- ken. Always wear eye protection to protect eyes from dirt and other foreign objects.

When threading pipe 3/4″ or larger, use the No. 691

Support Arm to resist high handle force devel- oped during threading.

Installation of Adapter

Adapter is required for 1/8″ through 11/4″ 11-R Die Heads. Push Adapter into Power Drive until spring engages securely (Figure 2). Installation can be made from only one side of the Power Drive.

Figure 2 – Installation of 11-R Die Head Adapter

Ridge Tool Company 5