Glossary of Terms (Continued)

Line Pressure Gauge

Displays the current line pressure. It is regulated by the regulator knob.

Cut-in/Cut-off Pressure

Specific psi at which a compressor starts and stops while refilling the air tank.

Unpacking and Checking Contents

1.Remove the air compressor from the carton.

2.Place the compressor on a secure, stationary work surface and look it over carefully.

!WARNING:

Do not operate unit if damaged during shipping, handling or use. Damage may result in bursting and cause injury or property damage.

!WARNING:

For your own safety, never operate unit until all assembly steps are complete and until you have read and understood the entire operator’s manual.

!WARNING:

To reduce the risk of injury, if any parts are missing, do not attempt to operate the air compressor until the missing parts are obtained and installed cor- rectly.

Installation

1.Check and tighten all bolts, fittings, etc., before operating compressor.

2.Operate compressor in a ventilated area so that compressor may be properly cooled.

3.Compressor should be located where it can be directly plugged into an out- let. An extension cord should not be used with this unit.

4.To avoid loss of power and overheat- ing, additional air hose must be used to reach work area instead of exten- sion cords.

10