RIDGID R8408 manual Using AN iPod with the Job-site radio/ race scanner, pin Connectors IPod

OPERATION

USING AN iPod WITH THE Job-site radio/ race scanner

See Figures 22 - 24.

FOR DOCKABLE iPods (with 30-pin connector):

Select AUX 1 MODE.

Open the drop-down compartment door by pulling up on the latch handle.

Orient the iPod face up as shown and slide the unit under the retainer strap.

Make sure that the 30-pin connector on the iPod is aligned with the 30 pin connector in the door and that the iPod is pushed down completely to ensure proper docking.

The iPod must be ON and in PLAY mode for sound to be heard through the speakers.

The iPod will recharge while playing. The iPod will recharge when docked, even if the radio power is OFF.

All iPod controls can be used normally while the unit is docked, with the exception of the volume. Volume is controlled through the volume control knob on the radio.

Turning the radio OFF while the iPod is docked will NOT turn the iPod OFF.

To remove the iPod from the dock, simply pull upward to disconnect.

To protect the iPod from environmental hazards such as dust, moisture, etc., the drop-down compartment door must be closed and latched.

For complete operating instructions for the iPod, always refer to the manual that was included with your iPod model.

LCD DISPLAYS

AUX 1 MODE

Fig. 22

RETAINER

STRAP

30-pin

connectors

iPod

Fig. 23

20