LCD Displays UX 2 Mode | RIDGID R8408 instruction

OPERATION

FOR NON-DOCKING iPods, OTHER MP3 PLAYERS, AND CD PLAYERS:

Select AUX 2 MODE.

Open the drop-down compartment door by pulling up on the latch handle.

Make sure the iPod/MP3 player will fit inside the compartment provided.

NOTE: CD players will not fit.

The retainer strap may be used to secure the iPod/MP3 player into position.

CD players can simply be placed on the foam padding on the inside of the compartment door. The compartment door cannot be closed when a CD player is connected.

Connect one end of a 3.5 mm audio patch cord (maximum 8 in. long) to the iPod/MP3/CD player.

Connect the other end of the 3.5 mm patch cord to the AUX 2 jack provided.

Make sure that the audio patch cable is positioned so that it is not pinched if the door is closed.

The iPod/MP3/CD player must be ON and in PLAY mode for sound to be heard through the speakers.

All iPod/MP3/CD player controls can be used normally while connected to radio.

NOTE: Volume for any device connected through the AUX 2 jack is adjusted using the volume control for that device.

Turning the radio OFF will NOT turn the iPod/MP3 player OFF.

To protect the iPod/MP3 player from environmental hazards such as dust, moisture, etc., the drop-down compartment door must be closed and latched.

The AUX 2 jack DOES NOT provide charging function.

For complete operating instructions for all iPod, other MP3 players, and CD players, always refer to the manual that was included with your model.

Most CD players are too large to fit inside the internal compartment. To use these devices, open the drop-down compartment door to access the AUX 2 input jack, and connect the device as described above. Turn on the CD player and adjust the volume to the desired level.