ASSEMBLY
attaching the wheel assembly and
SUPPORT FOOT
See Figures 3 and 4.
nLocate the support feet, nuts, and bolts.
nLift the machine and slide the support feet into the machine base.
nSecure in place using the bolts and nuts.
nLocate the axle, hitch pins, washer, and wheels. Remove the hitch pin from the axle.
nSlide the axle through the hole in the center of the wheel.
nSlide the washer onto the axle.
nLift the machine and slide the axle into the wheel mount- ing hole in the machine base as shown.
nPush the hitch pin into the hole on the end of the axle to secure the wheel assembly.
NOTE: The hitch pin should be pushed into the axle until the center of the pin rests on top of the axle.
nRepeat with the second wheel.
attaching the trigger handle rest
See Figure 5.
nLocate the trigger handle rest (front and back), screws, flat washer, and lock nut.
nPush the screws into the holes. Tighten securely using the lock nut.
RAISING AND LOWERING the handle
See Figure 6.
nTo raise the handle: pull the handle up until the handle knob snaps through the locking hole to secure the handle in place.
nTo lower the handle: pull the handle knob out then lower the handle to the position shown in figure 6.
CAUTION:
Failure to remove pump oil plug label may result in decreased pump life.
REMOVE the LABEL
See Figure 6.
Remove pump oil cap label from the oil pump.
nut 
support foot
bolts
Fig. 4
TRIGGER HANDLE
REST (BACK)
SCREW
SCREW
LOCK
NUT
flaT
washer
| Fig. 5 | |
| raising and lowering handle | |
handle | handle | |
knob | ||
|
label 
Fig. 6
10
