RIDGID TS2400, AC9930 manual Portable Power Tools with a Small Base, See Figures 16, 17

ASSEMBLY

SEE BOLT VIEW A

SEE BOLT VIEW B Fig. 14

nRemove mounting blocks from table. Attach power tool to mounting blocks with 1/4-20 carriage bolts, washers, lockwashers and nuts as shown. Reinstall mounting blocks to work stand table.

NOTE: See views of bolt recommendations, see figure 15.
2 X 6	POWER
	TOOL

WORK

STAND

BOLT VIEW A	BOLT VIEW B
(2 X 6s WORK STAND)	(POWER TOOL TO 2 X 6s)
	Fig. 15

Portable Power Tools with a Small Base

See Figures 16, 17 and 18.

(Tool mounting holes do not span 2 x 6 mounting blocks shown.)

nPlace the stand in the set-up position as shown.

nUsing the stand’s table as a pattern, locate the 2 x 6 s as shown, and from the bottom mark hole locations.

nDrill 1/4 in. or 3/8 in. diameter holes in the two 2 x 6 x 24 in. long mounting blocks as shown.

SET-UP POSITION

Fig. 16

nTemporarily attach the mounting blocks to work stand with the supplied bolts or 1/4-20 bolts at least 2-1/2 in. long. Secure with washers, lockwashers and nuts.

nLocate and drill holes in 2 x 6 mounting blocks and 1 x 4 cross pieces, as shown. Plywood 3/4 in. thick, 24 in. x 27 in. may be used in place of the 1 x 4 s.

nLoosen 2 x 6 mounting blocks from work stand table. Attach two 1 x 4 cross pieces to the mounting blocks with 1/4-20 carriage bolts at least 2.75 inches long, as shown. Secure with washers, lockwashers and nuts.

NOTE: A 5/8” diameter counterbore 1/4” deep is required for clearance between the bolt head and the

SEE BOLT	PLYWOOD	SEE BOLT
VIEW A		VIEW A-1

SEE BOLT	SEE BOLT
VIEW B		Fig. 17
	VIEW C

work stand table. Tap carriage bolt with hammer to seat bolt fully into the hole and counterbore. Resecure 2x6 mounting blocks to work stand table.

If using plywood, the supplied 1/4-20 bolts may be used to attach the 2 x 6s and plywood to the work stand table. When mounting table saws to plywood an opening for the sawdust to fall through is needed. See your tools owner’s manual for recommended hole size.

See views of bolt recommendations, see figure 18.

n To attach power tool, locate and drill holes in cross pieces.

nAttach power tool to cross pieces with 1/4-20 carriage bolts as shown with washers, lockwashers and nuts.

	BOLT VIEW A	WORK	BOLT VIEW A-1
(2 X 6s TO WORK STAND)			(PLYWOOD AND 2 X 6s
	2 X 6	STAND	TO WORK STAND)
			2 X 6
		POWER	1 X 4 OR
	1 X 4	TOOL	PLYWOOD
			2 X 6
	2 X 6		BOLT VIEW C
	BOLT VIEW B		(POWER TOOL TO
			1X4s OR
(1 X 4s TO 2 X 6s)		WORK STAND	Fig. 18

10