Rinnai EX11C (RHFE-265FTA) Flue Manifold Installation, Install the Terminal Terminal seal

Flue Manifold Installation

4. Install the Terminal

Terminal seal

Check that the terminal seal is in place. For weatherboard walls, add the second seal next to the terminal seal to compensate for weather board angle.

From the outside insert the terminal into the
sleeve with the marking “TOP” at the top.
The left hand side locking tie should be	Terminal
marked “LEFT”.

	Locking tie
5. Lock the ties
Pulling hard on the left and right hand ties,	Locking ties
clip the ties over the notches inside the		Sleeve
sleeve. You should be able to pull the ties 2
or 3 notches past the starting point. Cut the
ties, leaving about 3/4 inch (20 mm) past the
notch. Bend the ties back into the sleeve and
parallel to the wall.

6.Insert Inside Connection Assembly

Push the assembly into the terminal tube, ensuring that the seal is in place on the inner tube.

Attach the inside connection with 3 screws. The inner connection can still be turned to install the screws.

3 screws

22 Rinnai Corporation EX08C, EX11C Manual