Rinnai R98LSE-ASME Temperature Controller Installation, Mounting on the wall, Cable Clamp

Temperature Controller Installation

Mounting on the wall

1.	Determine a suitable location for the
	controller.
2.	Make three holes in the wall as shown.

Outline of Temperature controller

3.	Run the cable between the controller and the
	Rinnai water heater or the controller and
	another controller.
4.	Remove the face plate from the temperature
	controller using a screw driver.
5.	Connect the cable to the temperature controller.
6.	Mount the controller to the wall using the
	holes drilled in step 2.

securing screw

wiring hole

securing screw

1-21/32"

3-5/16"

Connecting to the R75LSe, R94LSe, R98LSe, and R98LSe-ASME

7.Disconnect the power from the Rinnai water heater.

8.Remove the cover of the Rinnai water heater.

9.Remove the plastic cover from the PCB and electrical connections.

10.Thread the cable through the access hole at the base of the unit and connect the wires to the controller terminals on the right hand side bottom of the PCB.

11.Secure the controller cable using the clamp provided.

12.Replace plastic cover over PCB and then replace the cover of the Rinnai water heater.

TEMPERATURE CONTROL

CONNECTION TERMINALS

TEMPERATURE

CONTROL CABLE

CABLE CLAMP

VA Series Outdoor LS Manual 31