Rinnai RHFE-1510F stop end, Flue Tube of Unit, Connection Manifold, Terminal Body, Sleeve plate

Models: RHFE-1510F

1 18

Page 11

Example of flue tube extension

Connection Manifold

Terminal Body

Put grease on connecting O-rings.

Use the same air inlet hose length as the length of the flue manifold.

Flue Tube of Unit

stop end

Image 11

Contents

17.4 MAINTENANCE27TROUBLESHOOTNG THE HEATER damage DO NOT INSTALL, contact your supplier WarrantyInstallation Instructions Page Minimum Distances Flue Terminal Positiongases and vapour come out from flue terminal in point Swing Louvre Warm airFlue Terminal Open the gas valve fullyPage Terminal Body Sleeve PlateConnection Manifold must be used Rear Sides Fixingstop end stop endstop end Flue Tube of UnitThis is done by pulling the outside terminal CAUTION 240V inside unit Testing the UnitWiring Diagram Fault Codes Dip Switch SettingsRinnai UK MAINTENANCEdust thisplate TROUBLESHOOTING THE HEATERRefer to the list below 9 Christleton Court Manor Park Runcorn WA7 1ST If you require service please ring the contact number on this pageStatutory Regulation, and must be installed CUSTOMER OPERATING AND INSTALLATION INSTRUCTIONSThis appliance shall be installed in accordance with these Manufacturers Installation Instructions