| SECTION 6: MCARING FOR THE HEATER | |
Thermostat | There should be no exposed wire or damage to the thermostat. | |
| Safety wall tag must be mounted over thermostat. | |
| Contact a licensed contractor for repair. | |
|
|
|
Suspension Points | Make sure the heater is hanging securely. Look for signs of wear on the chain | |
| or ceiling. | |
| Contact a licensed contractor for repair. | |
|
|
|
Protective Grille (included | The grille must be securely attached. | |
in select models) | Contact a licensed contractor for repair. | |
| ||
|
|
|
Bird Screen | Make sure nothing is lodged in the screen. Immediatly remove objects. | |
| The screen must be securely attached. If the screen is loose or off, contract a | |
| licensed contractor for repair. | |
| See Page 16, Figure 9 for location of bird screen. | |
|
|
|
6.4 Basic Heater Care
•Make sure the heater is off and cool. Dust the burner, reflector and control compartment off with a dry cloth. Increase cleaning frequency if the heater is in an area where excessive dirt, dust or lint mate- rial etc. can build up.
•Do not use the heater in an area containing corro- sive chemicals.
•Do not install or use the heater outdoors.
•Do not use the heater if any part has been under water. Immediately call a licensed contractor to inspect the heater and to replace any part of the control system which has been under water.
•Do not paint any part of the heater.
6.5 Replacement Parts
Use only genuine ROBERTS GORDON® replace- ment parts.
Use of parts not specified by
WARNING
Burn Hazard
Do not touch any part of the heater when running. Heater is very hot.
Heater must be off and cool before cleaning.
Failure to follow these instructions can result in injury.
WARNING
Cut Hazard
Do not touch edges of heater.
Edges are sharp.
Failure to follow these instructions can result in injury.
19
