CGTH USE AND CARE MANUAL
SECTION 6: CARING FOR THE HEATER
To ensure your safety and years of
6.1 Annual Inspection
Before every heating season, a licensed contractor must perform a thorough inspection of the heater. s, electrical and thermostat connections as well as the venting and suspensions are some of the areas requiring inspection.
6.2 Monthly Inspection
The owner must visually inspect the heater each month using the checklist on Page 18, Section 6.3. Check only the itemson this list and follow the instructions given.
6.3 Maintenance Checklist
WARNING
Turn off gas and electrical supplies before performing service or maintenance.
Failure to follow these instructions can result in death, injury or property damage.
Installation Code and Annual Inspections:
All installations and service of ROBERTS GORDON® products must be performed by a contractor qualified in the installation and service of products sold and supplied by
To help facilitate optimum performance and safety,
The Vicinity of the Heater | Do not store or use flammable objects, liquids or vapors near the heater. |
| Immediately remove these items if they are present. |
| Keep the heater clear of clothing, furniture, draperies or other combustible |
| materials. Children and adults should be alerted to the hazards of high sur- |
| face temperatures and should stay away to avoid burns and clothing ignition. |
| Young children should be carefully supervised when they are in the same |
| room as the heater. |
|
|
Vehicles and Other | Maintain the clearances to combustibles. |
Objects | Do not hang anything from, or place anything on, the heater. |
| |
| Make sure nothing is lodged underneath the reflector, in between the tubes or |
| in the decorative or protective grilles (included with select models). |
| Immediately remove objects in violation of the clearances to combustibles. |
|
|
Power Cord | There should be no exposed wire on the cord or damage on the plug. |
|
|
Inside Venting | Venting must be intact. Using a flashlight, look for obstructions, cracks on the |
| pipe, gaps in the sealed areas or corrosion. |
| The area must be free of dirt and dust. |
| Remove any carbon deposits or scale using a wire brush. |
|
|
Outside Air Inlet | Inlet must be intact. Look for obstructions, cracks on the pipe, gaps in the |
| sealed areas or corrosion. |
| The area must be free of dirt and dust. Clean and reinstall as required. |
|
|
Tubes | Make sure there are no cracks. |
| Contact a licensed contractor for repair. |
|
|
Gas Line | Contact a licensed contractor for repair. |
|
|
18