Automatic Plug and Play setup
When your Clock Radio is first connected to the mains supply, or after a power failure (when backup battery is not installed), the Auto setup will proceed as follows:-
•Your radio will show "FM 87.5", then automatically search all wavebands and store stations in presets.
•Automatically set the time and day of week.
1.Connect to mains (see page 6). Your radio will scan through the FM waveband, storing stations of sufficient strength as presets.
Note: To interrupt the automatic tuning, press the Prog/Random button once.
2.Your radio is ready for use when the FM waveband has been fully searched.
After having performed the automatic memory set up process, the display will show a DEMO briefly introducing the RDS features.
3. The Clock Time (CT) indicator will flash in the display whilst time | 5 | |
setting is carried out. | ||
| ||
Note: To interrupt the automatic time set, or stop the DEMO mode, press | 5 | |
any button once. |
4.If the first station detected by the automatic setup does not carry CT information your radio will automatically change to another
station after | 5 |
set. |
5.Press the BAND button to switch on your radio and press the up and down buttons to select a preset station. Adjust the volume using the VOLUME control. To switch off your radio press the StandBy button.
Note:- Auto setup can take up to 5 minutes to complete and is dependent on the signal strength and number of stations in your area.
Should Auto setup fail, setting the clock and
If you need any further advice, please call our Technical Helpline on :-
020 8758 0338 | 8 |
|
