Important Information - please read before use
To assist the auto setup of your clock radio it is recommended |
|
that, before connecting your radio to the mains supply, to fully |
|
extend the pig tail aerial on the rear of your clock radio and |
|
place your clock radio in a position where radio reception is |
|
best. | 1 |
Note: The two LR6 (AA size) batteries provide power for |
the clock/memory backup and must be fitted at all times.
Battery operation
1. Remove the Battery cover on the base of your CD clock radio by
pressing the tab on the cover and lifting in the direction of the arrow. |
| |
Insert 2 x LR6 (AA size) batteries into the spaces in the compartment. | Remote Control | |
Observe the correct battery polarity as shown inside the battery | ||
| ||
compartment. Replace the battery cover. |
|
2.Remove Battery cover on base of your remote control by rotating the cover to the Open position. Insert 2 x LR03 (AAA size) batteries into the spaces in the compartment. Observe the correct battery polarity as shown inside the battery compartment. Replace the battery cover.
2
Mains Operation
1.Place your radio on a flat surface.
2.Plug the mains plug into a wall socket and switch on the wall socket.
Note: The unit remains connected to the mains even when it is switched off. The unit is only isolated from the mains if the mains plug is removed from the wall socket.
If you need any further advice, please call our Technical Helpline on :-
020 8758 0338 | 6 |
|
