7.Press the Tuning Up or Down buttons to see the SSID for each access point that the clock radio has found. If your network is shown proceed to step 9.
7 | 7 |
8. If your network is not found, it is possible that it is confi gured such that |
|
the SSID is not broadcast (sometimes referred to as hidden). If this |
|
is the case then use the Back button and then select 'Enter network |
|
name'. This procedure is described page 56, 'Entering the network |
|
name manually'. If you know that your network name is not hidden, and |
|
it was not found,then either try |
|
and if necessary try moving your clock radio to a location closer to | 8 |
your access point / router, or refer to 'Troubleshooting' on page 61. |
If you make a mistake at any point, use the Back button to go back to the previous screen.
9. When the SSID for the access point you want to connect to is displayed
on the screen, press the Select button.
9
10.Ifyournetworkisnotconfiguredtoneedanencryptioncode,thescreen should say 'Connecting to network', then 'Network OK'. If this is the case then you have successfully connected your clock radio to your network, so please proceed to the section 'Once your clock radio is connected to the network' on the next page.
11.If the screen displays either 'Enter WEP key' or 'Enter WPA key', it is because the network is using one of the encryption systems: Wired Equivalent Privacy (WEP) or
If you need any further advice, please call our Technical Helpline on :-
Configuration
020 8758 0338
10