OPERATION
SETTING THE BEEP
You can set the telephone cassette re- corder to beep every 15 seconds while recording.
Note: You might be legally required to set BEEP TONE to ON when recording, so all parties know the conversation is being recorded. Check the laws in your area.
1.Remove the battery compartment cover and remove the batteries, if installed.
2.Set BEEP TONE to ON. The tele- phone cassette recorder beeps ev- ery 15 seconds while recording.
|
| EQUIPMENT, OR REPLACING BATTERIES. |
| + | |
DC 6V | + | |
BEEP TONE |
|
|
| + | |
ON | OFF |
|
| + |
2.Press STOP/EJECT to open the cas- sette compartment door. Put the cassette in the compartment with the cassette’s open edge facing you and the full reel on the left.
3. Close the door.
Notes:
•You can buy cassettes of varying lengths at your local RadioShack store.
•Replace the tape at least once a year, or more often if it is used heavily.
3. Replace the batteries and the cover.
LOADING A CASSETTE TAPE
Follow these steps to install a cassette tape (not supplied) in the recorder.
1.Turn the cassette’s hub with a pencil to take up any tape slack.
RECORDING A PHONE CONVERSATION
You can record both sides of a conver- sation on any phone connected to the same phone line as the recorder.
1.Set REC MODE, the sensitivity level, SPEED, and MONITOR to the desired settings. (See “Setting the Record Mode” on Page 9, “Setting the Sen- sitivity Level” on Page 9, “Setting the Recording Speed” on Page 10, and “Listening While You Record” on Page 10.)
8
