Rockford Fosgate 5.3x manual 5.3X INSTALLATION, High Level Input - “Single Ended” Type

5.3X INSTALLATION

High Level Input – “Single Ended” Type

This configuration is used for source units that have “Single Ended” speaker outputs. Only the “+” output is “hot,” whereas the “–” or “common” are common grounded. To verify your source unit has these outputs, connect an ohm meter across the “–” output and radio chassis for a reading of 0Ω.

R

	AUD		CLOCK	AUTO		ILLUM	SEL
	DISC	Ch	DSPL	P.SCN		LOUD
VOL	AMFM	ST LD RDM RPT					TUNE
	PWR	D.SCN SCAN		RPT	RDM	DIM
							PAUSE
		1	2	3	4	5	6

		Front	Rear
	R+			L+
COMM				COMM
	L+			R+

LED			L-Subwoofer +LF– +RF– GND +LR–		+RR– Front	Rear	Sub
	LF	LR
	RF	RR	High Level Inputs		Gain	Gain	Gain
			R-Subwoofer
			Use “Configuration #6” of	Use “Configuration #3” of Signal
			Signal Switching Network	Switching Network when using
			when using front inputs only		front & rear inputs

•L+ and R+ Inputs are connected to corresponding “+” speaker outputs

•L– and R– Inputs are not used

•GND Input is connected to “–” speaker outputs

•Configuration #6* is used with FRONT inputs to achieve Sub output

•Configuration #3* is used with FRONT & REAR inputs to achieve Sub output

* Refer to previous pages for Signal Switching Network configurations

CAUTION: Use 1/8" female connectors when using the high level inputs and DO NOT solder wires directly to the connector

I

N

S T A L L A T I O N

– 24 –