TROUBLESHOOTING
OR
3.Remove existing ground wires for all electrical components. Reground wires to different locations. Verify that grounding location is clean, shiny metal free of paint, rust etc.
OR
4.Add secondary ground cable from negative battery terminal to the chassis metal or engine block of vehicle.
OR
5.Have alternator and battery load tested by your mechanic.Verify good working order of vehicle electrical system including distributor, spark plugs, spark plug wires, voltage regulator etc.
ACCESSORIES
PUNCH Capacitors
Maintain the power you need to your Punch Amplifier.
PUNCH Install Kits
A variety of install kits are available to help you install your Punch amplifier like a professional.
Para-Punch Remote Bass Control
This adds an adjustable center frequency control with the adjustable boost control.
See our web site for other accessories to help you get the most out of your system.
www.rockfordfosgate.com
SPECIFICATIONS
MODEL- | PUNCH 45 | |
Continuous Power Rating (RMS) - |
| |
Measured at 14.4 Battery Volts |
| |
4 | Load Per Channel | 22.5 Watts x 2 |
2 | Load Per Channel | 35 Watts x 2 |
4 | Load Bridged (Mono) | 70 Watts x 1 |
Dimensions: |
| |
| Height | 2.6" (6.60cm) |
| Width | 11.2" (28.45cm) |
| Length | 11.7 (29.72cm) |
Amplifier Fuse Rating (Amp/Type) | (1) 30A / ATC | |
Battery Fuse Rating (Amp) External | 30A | |
(Not Supplied) |
|
|
>80dB | ||
Crossover Slope | 12dB/octave Butterworth | |
Crossover Frequency | variable from 40Hz to 400Hz | |
Frequency Response | 20Hz to 20kHz ±0.5dB | |
Bandwidth | 20Hz to 200kHz ±3dB | |
Slew Rate |
| 30 Volts/µS |
IM Distortion (IHF) |
| <0.05% |
Signal Voltage Adjustment Range | Variable from 150mV to 4V (RCA Input) |
Protection | NOMAD - Internal |
| circuitry limits power in case of overload, plus short |
| protection.Thermal switch shuts down the amplifier |
| in case of overheating. |
Equalization (45Hz Punch Bass) | Variable from 0dB to +18dB @ 45Hz |
Input Impedance | 10k ohms |
These specifications are Amplifier Power Standard
Specifications subject to change without notice
10