INSTALLATION
REMOTE PUNCH BASS
Mounting and installation
1.Find a location, either under the dash or near the center console, that gives easy access to the remote.
2.Using the screws supplied, install the mounting clip with the tabs towards the back.
3.Route the cable for the remote and connect to both the remote and amplified subwoofer.
4.Slip the remote onto the mounting clip until it snaps into place.
5.Install the decal and knob onto the remote.
Mounting
Clip
Knob Decal
OPERATION
ADJUSTING GAIN
To adjust the gain setting, turn the amplifier gains all the way down. Turn the source unit volume up until distortion is audible and then turn it down a bit until the distortion is inaudible. This will be about two thirds all the way up on most source units. Next, turn the amplifier gain setting until once again distortion is audible and then back it down until the distortion is inaudi- ble. Rockford Fosgate source units do not distort, so the volume can be used at maximum setting.
NOTE: For a more in depth setting procedure, contact Rockford Technical Support.
ADJUSTING CROSSOVER FREQUENCY
Placing the switch in the Full position sets the amplifier to the full range frequency mode, preventing any crossover adjustment.
Placing the switch in the LP position allows the crossover frequency to be adjusted between
Turn the crossover adjustment knob all the way down. With the system playing, turn the crossover adjustment knob up slowly until the desired crossover point is achieved.
8
