DESIGN FEATURES
1 | 2 | 3 | 4 | 5 | 6 | 7 |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
8 | 9 | 10 |
1.Cast Aluminum Heatsink – The cast aluminum heatsink of the Punch amplifier dissipates heat generated by the amplifi- er's circuitry. The inherent advantage of casting provides a 30% improvement of cooling over conventional extrusion heatsink designs.
2.Gain Control – The input gain control is preset to match the output of most source units. It can be adjusted to match output levels from a variety of source units.
3.Variable Crossover – The amplifiers have a
4.RCA Input Jacks – The industry standard RCA jacks provide an easy connection for signal level input. They are
5.LED Power Indicator – The LED illuminates when the unit is turned on.
6.REM Terminal – This spade terminal is used to remotely
7.Power Terminals – The power and ground connectors on the Punch amplifier are
8.Punch Bass – The Punch Bass control helps correct for acoustical deficiencies in the listening environment by helping produce full range sound without adding excessive boost.. The Punch Bass control is a narrow band adjustment at 45Hz variable from 0dB to + 18dB. Connection is made with a cable using
9.RCA
10.Speaker Terminals – The heavy duty,
INSTALLATION
INSTALLATION CONSIDERATIONS
The following is a list of tools needed for installation:
Volt/Ohm Meter | Hand held drill w/assorted bits |
Wire strippers | 1/8" diameter heatshrink tubing |
Wire crimpers | Assorted connectors |
Wire cutters | Adequate |
#2 Phillips screwdriver | Adequate |
Battery post wrench | Adequate |
4