25
4 Basic Operation
4
1
3
2
4-5 When Performing Long CuttingCutting a length of 1.5 m (59 in.) or more requires
material that is at least 50 mm (2 in.) wider than the
necessary cutting width.
Prepare material that is at least
50 mm (2 in.) wider than the
necessary cutting width.
Refer to the figure at right and move the pinch rollers.
Position the pinch rollers so that each one is 25 mm (1
in.) from the respective left or right edge of the
material.
Raise the sheet loading lever to secure the material in
place.
1.5 m (59 in.) or more
25 mm
(1 in.) or more 25 mm
(1 in.) or more
Before performing material feed, pull out the required
length of material from the roll material.
Refer to the previous section, "4-4 Checking Material
Feed," and perform material feed.
If the material comes loose, then reload the material.