34
4 Basic Operation
1
2
3
4
4-9 Applying the Completed Cutout
When cutting ends, affix the material you created.
- Before you affix the material, cleaning the location where you want to affix it to remove any dust or grease.
- When applying on a transparent medium such as window glass, it may be helpful to draw guide lines on the back
of the glass with a water-based pen (so that the lines can be wiped off after applying the material).
- If air bubbles are formed under the affixed material, use a needle to pop the bubble, then press out the air to
obtain a complete seal.
Turn the dial to display the screen shown at right.
Press the [MENU/PARAM] key.
When the screen at right appears, press the [ENTER]
key.
The cutting carriage moves to the right.
Lower the sheet loading lever.
Remove the material.
SETUP | ON->OFF
SETUP | <ON>
Removing the Material
Piece Material