55
10 Display Menu Descriptions

10-1 How to Read This Chapter

The explanations in this chapter use the following format.
ROLL:
This performs cutting using roll material.
EDGE:
When using roll material, cutting is performed from the front-left edge of the
material.
* When the setting for [ROTATE] on the display menu is [ON], cutting is
performed from the front-right edge.
PIECE:
This performs cutting using standard-size material or piece material.
10 Display Menu Descriptions
Stored in Memory
Factory Default
Selection Choices
Description

SELECT

SELECT | ROLL No
ROLL
ROLL, EDGE, PIECE
FORCE | < 50g>
Stored in Memory
Factory Default
Setting Range
Steps
Description
Yes
50 g
30 to 200 g
10 g
This sets the blade force used when
cutting material.
Perform a cutting test and set the
conditions to match the loaded material
and the installed cutter.
This is the information
that appears on the
display.
This indicates the factory
default value.
This indicates the number
of steps required to set a
numerical value.
When set to "Yes," the
setting values are stored
in memory even when the
power is switched off.
This indicates the range in
which settings can be
made, or the range of
selectable choices.
This section provides an
explanation of functions
and matters that require
caution.

10-2 Display Menu Descriptions

To display the menu settings, press the [MENU/PARAM] key.
For detailed information on how to make menu settings, see 4-3 Turning on the Power - Making Menu Settings with the Control Panel.
* Only CX-24