Roland DIF-AT24 owner manual Sync Parameter screen YNC Parameter screen

Connections and settings

Settings

■Sampling Frequency settings

Set the sampling frequency of your sequencer software and the VS-2400CD to the same setting (44.1 kHz or 48 kHz).

■Master Clock settings

Master clock device	VS-2400CD setting		DIF-AT24
			MASTER CLK switch
VS-2400CD	PROJECT PARAMETER screen		R-BUS
	❍ MASTER CLOCL	INT
Sequencer software	PROJECT PARAMETER screen		ADAT
	❍ MASTER CLOCL	R-BUS

You'll also need to set the Master Clock for your sequencer software. For details on this setting, refer to the owner's manual for your sequencer software.

■Synchronization settings

Set the VS-2400CD's parameters as follows.

❑MMC settings

If using the sequencer software		If using the VS-2400CD as the MMC master
as the MMC master
MIDI PARAMETER screen		MIDI PARAMETER screen
❍ SysEx. Rx. Sw	On	❍ MIDI OUT/THRU	Out
❍ MMC MODE	SLAVE	❍ SysEx. Tx. Sw	On
❍ MMC SOURCE	R-BUS	❍ MMC MODE	MASTER

❑ MTC settings

If using the sequencer software		If using the VS-2400CD as the MMC master
as the MMC master
SYNC PARAMETER screen		YNC PARAMETER screen
❍ SYNC MODE	EXT	❍ SYNC MODE	INT
❍ EXT SYNC SOURCE	R-BUS	❍ FRAME RATE	Select the MTC
❍ FRAME RATE	Same setting as the		type.*
	software.*	❍ MIDI OUT SYNC Gen	MTC

*Check the specifications of your sequencer software, and set your software and the VS-2400CD to the same frame rate.

In order to synchronize operation with your sequencer software, you'll also need to make settings in the sequencer software. For details on these settings, refer to the owner's manual for your sequencer software.

11