Introduction

3.Firmly tighten all of the screws and stand the instrument back up.

When lifting the instrument back up, grasp near the center of the speaker box and the F-90, and gently raise the instrument.

If the Stand is Uneven

If after lifting the F-90 back up you find that stand is crooked, try loosening the screws and then securing them again. When retightening, start with the top screws, then work your way down. When doing this, slightly loosen the screws before firmly tightening them.

4.Place the caps over the heads of the screws (four on each side).

Caps

5.Connect the speaker cable extending from the rear of the speaker box to the F-90’s speaker connector.

Press the speaker cable completely into the connector so

When Moving the Instrument

Disconnect the AC cord, cables and the music stand from the F-90.

Then lift the piano while keeping it level, and move it with care, so that you do not drop it on your feet, or get your hands caught.

When Disassembling

Disassemble the unit by carrying out assembly Steps 1-5 in reverse order.

When Changing the Orientation of the Speaker Box

Be sure to completely disassemble the unit, change the

speaker box orientation, then reassemble it.

that it is securely fastened.

Clip Portion

Hold and insert the cable so that the clip portion extends into the stand and is securely connected.

F-90 Rear

Speaker Connecter

Speaker cable

7

Page 7
Image 7
Roland F-90 owner manual If the Stand is Uneven, When Moving the Instrument, When Disassembling