Contents
Main
CAUTION
For the USA
`
FEDERAL COMMUNICATIONS COMMISSION RADIO FREQUENCY INTERFERENCE STATEMENT
For Canada
Typographic Conventions
NOTICE
Page
Page
To Ensure Correct Use
Thanks and Best Wishes
TABLE OF CONTENTS
1 PRECAUTIONS
2 CHECKING SUPPLIED ITEMS 3 PART NAMES AND FUNCTIONS
4 BASIC OPERATION
5 SETTINGS FOR EACH FUNCTION
1 PRECAUTIONS
When Moving the PNC-900...
Precautions Regarding Placement
Precautions in use
2 CHECKING SUPPLIED ITEMS
3 PART NAMES AND FUNCTIONS
Front View
Rear View
Operation Panel
POWER/ERROR LED
SETUP LED
SETUP
PAUSE
4 BASIC OPERATION
4-1 Making the Connection with the Computer
4-2 DIP Switch Settings
* DIP switches settings must be made only when the power is turned off.
4-3 Installing the Blade
*Take care not to break or chip the blade.
Installation
Removal
7
4-4 Loading the Sheet SETUP Key
Turning on the Power
Loading the Sheet
The SETUP LED lights up and the tool carriage moves to the origin. Loading the sheet is completed.
The SETUP LED goes out and the tool carriage moves to the right edge of the cutting area.
4-5 Setting the Origin Point , , , , ORIGIN SET Keys
4-6 Cutting Test to Check Blade Force , , , , and TEST Keys
How to Adjust Blade Force
4-7 Downloading Cutting Data
Software Settings
Pausing Cutting Operations PAUSE Key, PAUSE LED, and SETUP Key
4-8 Applying the Completed Cutout
12
4-9 When Cutting Is Completed
* For routine cleaning, use a soft piece of cloth.
Performing a Demo Cutting
* A computer is not required in order to carry out the self-test.
5 SETTINGS FOR EACH FUNCTION
Using the Sheet Effectively (Rotate function) ROTATE Key and ROTATE LED
Canceling the Rotate Function
0 Rotation
90 Rotation
Page
6 ABOUT THE BLADE
If the blade becomes dull
Average blade life
7 WHAT TO DO IF...
If the PNC-900 doesn't run... PNC-900
Computer
Connection cable
Software
The sheet is not cut properly
The sheet slips away from the pinch rollers during the cutting process
8 LIST OF CAMM-GL III INSTRUCTIONS
mode1
mode2
Instructions in mode1 and mode2
9 LIST OF DEVICE CONTROL INSTRUCTIONS
Page
10 LIST OF OPTIONS
11 SPECIFICATIONS OF PNC-900
, , ,
Interface Specifications
Signal number Terminal
number Signal
number Signal
number Pin Connection