201

Appendices

Troubleshooting

If you think there’s a problem, read this first.

Case Cause/Remedy
The power doesn’t come on

Is the power cord connected and plugged in correctly? (p. 19)

The button doesn’t work

Is the panel locked? (p. 191)
Cancel the Panel Lock function.
Turn the power off, then back on.

Nothing appears on screen

The RM-700 uses a liquid-crystal screen, so text may not be displayed when the ambient temperature is below
freezing.
Is the panel locked? (p. 191)
Cancel the Panel Lock function.
Could the [Anime] button be on? (p. 94)
Press the [Exit] button or press the [Anime] button to turn off the Anime effect.

The touch screen doesn’t respond correctly

The positioning of the touch screen may become displaced if some time has passed since it was last used. Take a look
at “Calibrating the Touch Screen (Touch Screen)” (p. 188) to correct the positioning.

Depressing a pedal has no effect, or the
pedal effect doesn’t stop

Is the pedal connected correctly? (p. 19)
Has a different function been assigned to the pedal?
See “Assigning the Function of the Pedals (Left Pedal/Center Pedal/Expression Pedal)” (p. 179).
Normal pedal operation is automatically enabled when the One Touch Program [Piano] button is pressed (p. 28).

The pedal rattles

Adjust the adjuster underneath the pedal so that the pedal presses firmly against the floor surface (p. 22).

The volume level of the instrument
connected to Input jacks or Roland Audio
Port is too low

Could you be using a connection cable that contains a resistor?
Use a connection cable that does not contain a resistor.

Unable to read from/write to USB memory

Are you using (optional) Roland memory?
Reliable performance cannot be guaranteed if you use non-Roland memory products.
Try switching the Ext Memory Mode (p. 186).

Remote Control not functioning

No data from the remote control is received when the Remote Sensor is switched off.
Check “Switching the Remote Sensor On and Off (Ir Function)” (p. 184).

Performance begins unexpectedly

Could the Auto Start setting for Auto Demo be set to “On”? (p. 187)
If Auto Start is On, the demo will begin if no operation has been performed for five minutes.

No sound is heard

No sound is heard

Is the volume level of the RM-700 (p. 22) or connected device turned all the way down?
Are headphones plugged in? (p. 22)
Has a plug remained connected to the Phones jack?
When headphones or plugs are connected, the keyboard’s speaker stops playing.
Has the [Balance] knob been moved all the way to the right or left? (p. 70)
Has the volume been set to “0” using the Part Balance? (p. 70)
In the equalizer screen, could Master Level or Gain be set to the minimum? (p. 175)
Has the footage been adjusted so that all frequency components aren’t sounded? (p. 37)
Is the speaker cable connected and plugged in correctly? (p. 19)
Could the remote VOLUME [-] [+] buttons or the [MUTE] button be pressed to set the volume to “0”? (p. 84)
Even if the [VOLUME] knob is raised, there will be no sound if the remote VOLUME [-] [+] buttons or the [MUTE] button
have been pressed to set the volume to “0.”
Could a pedal be connected to the Control Pedal jack? (p. 192)
If the connected pedal is assigned to the “Expression” function (p. 179), there will be no sound unless you depress the
pedal.
The same holds true when Expression has been assigned to the Left Pedal or Center Pedal.
RM-700_e.book 201 ページ ２００９年３月１８日　水曜日　午前１１時５分