How to edit

1Press [EDIT] to enter the Edit mode.
2Select the parameter you wish to edit. Press [SELECT] to get the
appropriate indicator to light, thus selecting a column. Use [ ] or
[ ] to select the desired row, by getting the appropriate indicator
to light. (The display will show the value of the selected parameter.)
[SELECT] chooses the parameter group. The parameters of the SPD-20 are organized into
four groups: SOUND, MIDI, FX/PEDAL, and SYSTEM. With each press of [SELECT], the
indicator that lights (and the group that is selected), will be the next one in this group.
The [ ] and [ ] buttons are used to select parameters within the parameter groups.
The indicator above the currently lighted one will light when you press [ ], and the one
below the one currently lighted will light when you press [ ].
fig.19
In this illustration, the DECAY parameter in the SOUND parameter group is selected.
3Use PATCH/VALUE [-] or [+] to set the value. The previous value of
the parameter will be discarded. In the case of a numerical value,
PATCH/VALUE [+] increases the value, and PATCH/VALUE [-]
decreases it.
You can speed up the change in values by pressing [+] while holding down [-] (or vice versa).
4If you wish to edit another parameter, repeat steps 2–3 as neces-
sary.
5Press [EDIT] to return to the Play mode.
The parameter list indicators will go out, and the display will once again show the Patch
number.
TX CH
NOTE #
GT TIME
PAN
CURVE
SENS
PGM CHG
FX TYPE
FX TIME
FX LEVEL
PDL CTRL
PDL LEVEL
PDL CC #
BASIC CH
BULK DUMP
PATCH EXPAND
TRIG SENS
TRIG THRESHOLD
TRIG TYPE
TRIG CURVE
INST
LEVEL
PITCH
DECAY
PAN
CURVE
FX SEND
SELECT
MEMO
21
1
2
3
4
5