Setting the Pad’s Minimum Level (TRIG THRESHOLD)

By adjusting the TRIG THRESHOLD in the SYSTEM parameter group you can have a pad produce a
trigger signal only when struck with more than a certain level of force (a “threshold”). This can be used
to prevent a pad from sounding in response to extraneous vibrations from another pad. However, if
you strike the pad with a force less than the Trigger Threshold, it will not sound. In the diagram below,
the pad will sound for 2, but not for 1or 3. This parameter can be set over a range of 0–15.
fig.30
Factory Trigger Threshold (TRIG THRESHOLD) settings for the internal pad reflect the average
user´s preferences. If these settings produce good results for you, then there is no need to change the
Trigger Sensitivity values.
This parameter is set for all 8 pads, i.e., the same value applies to all pads. However, this parameter
can be set independently for each connected external pad.
Trigger Threshold (TRIG THRESHOLD) settings are common to all patches.
1In the Edit mode, select the SYSTEM parameter group (p. 21).
2Use [ ] or [ ] to select TRIG THRESHOLD.
fig.31
3Strike one of the 8 pads.
4Use PATCH/VALUE [-] or [+] to set the value.
For information on editing external Pad Trigger Parameters, please refer to p. 42.

12 3

Threshold Level
0
NOTE
MEMO
MEMO
31
1
2
3
4
5