Roper FGP335Y important safety instructions Removing the oven bottom, To remove, To replace

2.Hold the door at the sides near the top. Insert hinge arms into slots at the bottom of the door. Insert arms evenly, as far as they will go.

3.If the door is not in line with the oven frame, remove it and repeat the above steps.

4.Replace the screws on the oven door.

Removing the oven bottom

The panel in the oven bottom can be removed for cleaning.

Burn Hazard

Make sure all parts are cool before removing.

Failure to do so could result in burns.

To remove:

1.Remove oven racks.

2.Remove the two hold-down screws at the rear of the oven. If screws are too tight to remove by hand, use a screwdriver.

3.Place fingers in slots in bottom panel and lift rear of panel up and back until lip at the front of panel is clear of front frame of oven cavity.

4.Lift bottom up and out.

To replace:

1.Place oven bottom panel in oven with the back raised about 6 inches or until you can insert the hold-down lip at front of panel under the front frame of oven cavity.

2.Push back of oven bottom panel down fully into place on metal flanges on rear

wall and insert the hold-down screws. 19