Roper FGS395B important safety instructions Cause

	PROBLEM					POSSIBLE			CAUSE
Burner			fails		to	The power cord is not
light						plugged	into	a live		circuit with
						proper	voltage.
						A household fuse has blown
						or a circuit breaker has
						tripped.
						Burner	ports	are	clogged.
Burner			flames			Burner	ports	are	clogged.
are uneven
Burner			flames			Air/gas	mixture is incorrect.
lift	off	ports,			are
yellow,			or	are
noisy		when
turned			off
Burner			makes			Burner	is wet	from		washing.
popping			noise
when		on
Control			knob(s)			You are not pushing					in before
will	not		turn			turning.
Self-Cleaning						The Oven Selector				and Oven
cycle		will		not		Temperature		Control			are not
operate						set to CLEAN.

The range clock does not show the correct time of day.

The Lock Lever is not in the CLEAN position-all the way to the right.

The Start Time Dial does not show the correct time of day or the knob is not all the way out.

The Stop Time Dial is not set ahead to the time you want the self-cleaning cycle to stop.

SOLUTION

Plug the power cord into a live circuit with proper voltage. (See Installation Instructions.)

Replace household fuse or reset circuit breaker. In case of prolonged power failure, manually light burners (see page 8).

Clean with a straight pin (see pages 24 and 26).

Clean with a straight pin (see pages 24 and 26). If this fails, call an authorized Roper service technician for service.

Contact an authorized Roper service technician to check air/gas mixture.

Let dry.

Push control knob(s) in before turning to a setting.

Set both the Oven Selector and Oven Temperature Control to CLEAN.

Reset clock to show the correct time of day. (See page 11.)

Move Lock Lever all the way to the right.

Reset the Start Time Knob to show the correct time of day. Pull knob out all the way.

See Step 3 in “Setting the controls” on page 21 for proper setting instruc- tions.

continued on next page

29