Roper RGC3422A warranty Caring For Your Dryer, Maintenance-every load, Maintenance-as needed, Page

Caring For Your Dryer

In This Section	PWP		Page
IMaintenance-every load
	.......9	Maintenancbar needed	.......9

Dryers require regular maintenance. Follow the suggestions below to maintain your dryer properly.

Maintenance-every load

Cleaning the lint screen

The lint screen is located inside the dryer drum, on the back wall. Clean lt before each load. A screen blocked by lint can increase drying time.

1.Open the door and pull the lint screen straight out.

2.Squeeze body of lint screen lightly while pulling the cover off. See illustration.

3.Roll lint off the screen with your fingers. Do not rinse or wash the screen to remove lint. Wet lint is hard to remove.

4.Replace cover on lint screen body. Push the lint screen firmly back into place and close the door.

Product and Fabric Damage Hazard

Do not run the dryer with the lint screen loose, damaged, blocked or missing.

Doing so can cause overheating and damage to both the dryer and fabrics.

tint screen

cover

Maintenance-as needed

Use the following suggestions about cleaning and lint removal to maintain your dryer and keep it operating efficiently.

Cleaning a clogged lint screen

Laundry detergents and fabric softeners can cause a residue build-up on the lint screen. A clogged lint screen can extend drying times. Clean the lint screen every six months or more frequently if it becomes clogged due to a residue build-up. Use the following method:

1.Wet both sides of lint screen with hot water.

2.Wet a nylon brush with hot water and liquid detergent.

3.Scrub lint screen with the brush until all residue build-up is removed.

4.Rinse with hot water.

5.Thoroughly dry lint screen with a clean towel and replace in dryer.

9