Rotel RC-06 Volt Trigger Outlet t, Troubleshooting, Specifications, 9English, Fuse Replacement

9English

12 Volt Trigger Outlet t

Some audio components can be turned on automatically when they receive a 12V turn on “signal”. The 12V Trigger Outputs of the RC-06 provide the required signal. Connect compatible components to the RC-06 with a conventional 3.5mm miniplug cable. When the RC-06 is in Standby mode, the trigger signal is interupted, so the components controlled by it are turned off.

Troubleshooting

Most difficulties in audio systems are the result of incorrect connections, or improper control settings. If you encounter problems, isolate the area of the difficulty, check the control settings, determine the cause of the fault and make the necessary changes. If you are unable to get sound from the RC-06 refer to the suggestions for the following conditions:

Power Indicator Is Not Lit

The Power Indicator should be lit whenever the
RC-06 is plugged into the wall power outlet. If it
does not light, test the power outlet with another
electrical device, such as a lamp. Be sure the
power outlet being used is not controlled by
a switch that has been turned off.	Specifications
Fuse Replacement
If another electrical device works when plugged
into the power outlet, but the Power Indicator	Total Harmonic Distortion (20 Hz-20 kHz)	< 0.004%
of the RC-06 does not light when plugged into	Intermodulation Distortion (60 Hz : 7 kHz, 4:1) < 0.004% at 1V output
the same outlet and the Power Switch is pushed	Frequency Response
in, it indicates that the internal power fuse may	Phono Input (MM)	20Hz-20kHz, ±0.5dB
have blown. If you believe this has happened,	Line Level Inputs	4Hz-100kHz, ±3dB
contact your authorized Rotel dealer to get the	Input Sensitivity / Impedance
fuse replaced.	Phono Input (MM)	1.2mV / 68 kOhms
No Sound	Line Level Inputs	150 mV / 24 kOhms
	Input Overload
Check the signal source to see if it is function-	Phono Input (MM)	160mV
ing properly. Make sure the cables from the	Line Level Inputs	5V
signal source to the RC-06 inputs are con-	Output Level / Impedance	1 V/ 100 Ohms
nected properly. Be sure the Function Control	Usable Headphone Impedance	8 - 2,000 Ohms
and Monitor Control are properly set. Check	Signal to Noise Ratio (IHF “A” weighted)
the wiring between the RC-06 and the power	Phono Input (MM)	70 dB
amplifier. Be sure the power amplifier is on	Line Level Inputs	100 dB
and the speakers are properly connected. If	Power Requirements
the power amplifier has level controls be sure	USA Version	120 Volts, 60 Hz
they are set properly.	European Version	230 Volt, 50 Hz
	Power Consumption	10 Watts
	Dimensions (W x H x D)	437 x 72 x 328 mm
		171/8 x 27/8 x 1215/16”
	Front Panel Height	60mm
	Weight (net)	4.3 kg, 9.5 lbs.

All specifications are accurate at the time of printing.

Rotel reserves the right to make improvements without notice.