RuggedCom RS910L manual Ethernet Ports, Communication Standards

5.6 Ethernet Ports

5.6.1 Copper Ports

Parameter	Specification	Notes
Speed	10/100 Mbps	Auto-negotiating
Duplex	FDX / HDX	Auto-negotiating
Cable-Type	> Category 5	Shielded/Unshielded
Wiring Standard	TIA/EIA T568A/B	Auto-Crossover, Auto-polarity
Max Distance	100 m
Connector	RJ45
Isolation	1.5 kV	RMS 1-minute

Table 12: Ethernet Ports - Copper Specifications

5.6.2 Fiber Optic Ports

Speed	Mode /		Tx λ		Cable		Tx Pwr		Rx		Rx Saturation		Typical		Power
Standard					Type2		(dBm peak) 3		Sensitivity				Distance		Budget
	Connector		(nm)								(dBm Peak) 3
					(∝m)		(Min / Max)		(dBm Average) 3				(km) 1		(dB)
100Base-FX	MM / ST	1310		50/125		-15.7		-33.5		-11		2		17
100Base-FX	MM / SC	1310		50/125		-16/-11		-33		-11		2		17
100Base-FX	MM / LC	1310		50/125		-19 / -14		-32		-14		2		15
100Base-FX	MM / MTRJ	1310		50/125		-16/-11		-33.5		-11		2		17
100Base-FX	SM / ST	1310		9/125		-15/-8		-32		-7		20		16.5
100Base-FX	SM / SC	1310		9/125		-13/5		-31		-4		20		20
100Base-FX	SM / LC	1310		9/125		-15/-8		-31		-5		15		16.5

Table 13: Ethernet Ports – Fiber Optic Specifications

NOTES:

1.Maximum segment length is dependent on factors such as fiber quality, and number of patches and splices. Please consult RuggedCom sales associates when determining maximum segment distances.

2.To convert from average to peak add 3 dBm. To convert from peak to average, subtract 3 dBm.

5.7Communication Standards

Protocol	Standards
Ethernet	IEEE 802.3
Table 14 - Communication Standard Compliance
	25
 2007 RuggedCom Inc. All rights reserved	Rev100