11
PFP Controller Description
Front Panel
m
e
n
u
ratio
ratio
i
n
p
u
t
e
n
t
e
r
>
<
<
<
PIXEL FOR PIXEL
TM
1 2 3
4 5 6 7 8 9 10
1. IR RECEIVER
Receives the infrared signal from the remote control.
2.POWER BUTTON
Turns the unit ON or OFF. The Main Powerswitch on the rear of the unit must be on first for this button to be active.
3. POWER INDICATOR
When the PFP Controller is ON, this LED will illuminate GREEN. When the unit is OFF or in STANDBY, this LED will
illuminate RED. Aflashing red light indicates a fault. If this happens, unplug the unit for 2 minutes and re-try. A yellow
LED indicates a communication problem; double check that the ComLink cable is connected properly (page 10).
4. LED DISPLAY
Indicates the model number, current source, resolution and aspect ratio.
5. UP BUTTON
When no menu is present on-screen, this button will toggle you through the different aspect ratios.
When the menu is on-screen, the UPbutton will move the cursor up within a menu.
When an adjustment item has been selected (i.e. brightness), the UPbutton will increase the value of that function.
6. LEFT BUTTON
When no menu is present on-screen, the LEFTbutton will toggle you through the four different sources, in the order of:
RGB/Component Component S-Video Composite
7. ENTER BUTTON
When an item is highlighted on the On-Screen Display, the ENTER button will select the item. When in the
RGB/Component source and the installation mode is active, the ENTER button will enable the ‘Quick Menu’on the front
panel, which allows you to shift or blank the HD or computer image (see pg. 24).
8. DOWN BUTTON
When no menu is present on-screen, this button will toggle you through the different aspect ratios.
When the menu is on-screen, the DOWN button will move the cursor down within a menu.
When an adjustment item has been selected (i.e. brightness), the DOWN button will decrease the value of that function.
9. RIGHT BUTTON
When no menus are present on-screen, the RIGHTbutton will toggle you through the four different sources, in the order of:
Composite S-Video Component RGB/Component
10. MENU BUTTON
The MENU button brings up the main adjustment menu. After making adjustments, the MENU button will bring you back to
the sub-menu, then to the main menu. The menu will then either time-out after approximately 10 seconds, or pressing the
MENU button will remove the menu immediately.