Quick Menu
The 'Quick Menu' allows you to position and blank any signal sent through the RGB/Component input. This can be done without having to go through the standard menu, as the Quick Menu is done com- pletely from the front panel.
The Quick Menu is only available when you are in the RGB/Component source, and the instal- lation mode is active (pg. 21).
To use the quick menu, press ENTER on the front panel, and observe the front panel display. The fol- lowing will be displayed:
Quick Menu: Shifting
Press arrows or enter...
The first mode of the Quick Menu is SHIFTING. When this is displayed, press the up, down, left or right arrows to shift the image. For all of the adjustments, the quick menu will
If you do not need to make any position adjustments or you have completed making them, press ENTER again to display the next mode of the shift menu, which is for TOP BLANKING:
Quick Menu: Top Blanking
Press arrows or enter...
To adjust top blanking, press the up or down arrow buttons. Once the adjustments have been com- pleted, or no adjustment was needed, press ENTER. The final mode of the quick menu will be dis- played, which is for BOTTOM BLANKING:
Quick Menu: Bottom Blanking
Press arrows or enter...
To adjust bottom blanking, press the up or down arrow buttons. Once the adjustments have been completed, or no adjustment was needed, press ENTER. You will then exit the quick menu. If you need to
24
