Runco DTV-873 manual Peaking, Line Doubler, Color Select

Random Access Adjustment Mode

Peaking

Peaking improves the contours in a projected image. Highlight PEAKING by push- ing the control disc up or down and press ENTER to toggle the peaking between OFF and ON. During the creation of new settings for a RGB source the peaking is switched to OFF.

Line Doubler

This will turn the internal processor (which is actually a scaler with a 540p/33.8 Khz output) on or off. Typically, this should be left on; it will turn itself ‘off’ when a DTV or computer signal is input. When it is off, the image will run at a standard NTSC scan rate, which is 15.75 Khz.

Color Select

Highlight COLOR SELECT by pushing the control disc up or down and press ENTER to display the color select menu.

ENTER continues to the color select menu.

EXIT will return to Internal Crosshatch Selection or Setup Pattern Selection Menu.

ADJUST returns to operational mode.

Use the control disc to highlight a color (CRT) or combination of colors to display the projected image in that specific color.

To select a new color, press ENTER, the color selection menu appears.

ENTER continues to the color select menu.

EXIT will return to Internal Crosshatch Selection or Setup Pattern Selection Menu.

ADJUST returns to operational mode.

PICTURE TUNING

COLOR BALANCE

SYNC : FAST

PEAKING : OFF

LINE DOUBLER : ON

Select with or <ENTER> to accept <EXIT> to return.

RANDOM ACCESS

ADJUSTMENT MODE

PICTURE TUNING

GEOMETRY

CONVERGENCE

COLOR SELECT

Select with or <ENTER> to accept <EXIT> to return.

COLOR SELECT

RED

GREEN

BLUE

RED AND GREEN

BLUE AND GREEN

RED AND BLUE

Select with or <ENTER> to accept <EXIT> to return.

6-4