Runco PL-61DHD manual External Speaker Outputs, AUDIO1, AUDIO2, AUDIO3, COMPONENT1

Controls and Functions

1.POWER INPUT (100 to 240 VAC)

Connect the PlasmaWall to power here, using the included power cord.

2.EXTERNAL SPEAKER OUTPUTS

Not used. Connect speakers to an external audio amplifier/receiver.

3.VIDEO1, VIDEO2, VIDEO3 (BNC, RCA, S-Video)

Not used. Connect all video sources to the DHD Controller.

4.AUDIO1, AUDIO2, AUDIO3

Not used with this model. Connect the audio outputs from your sources to an external audio receiver.

5.COMPONENT1

Not used. Connect all video sources to the DHD Controller.

6.PC2/COMPONENT2 (5xBNC)

Connect the RGBHV (5xBNC) output from the DHD Controller here.

7.PC1 (15-pin D-Sub)

Not used. Connect all video sources to the DHD Controller.

8.PC3 (DVI)

HDCP-compliant digital video input. Connect the DVI output from the DHD

Controller to this input.

9.RS-232C (9-pin, male D-Sub)

A male, 9-pinD-sub connector. Connect the RS-232 OUT port on the DHD

Controller to this input.

10.REMOTE IN (3.5-mm mini phone jack, tip/ring/sleeve)

Wired input (3.0 VDC/300 mA) from an external remote control or infrared (IR) receiver.

11.REMOTE OUT (3.5-mm mini phone jack, tip/ring/sleeve)

Wired output to the REMOTE IN jack of another device; allows you to control both the PlasmaWall and the other device using the same wired remote control.

Runco PlasmaWall Owner’s Operating Manual 7