4. Operation

1.Turn on your source components.

2.Turn on the main power switch at the rear of the DHD Controller.

3.Press the ON button on the remote control -- or the POWER button on the DHD Controller front panel -- to turn on the system. The vacuum fluorescent display on the DHD Controller front panel briefly displays “Starting Display.”

4.When the projector is ready for use, the fluorescent display indicates the active source, signal format (NTSC or PAL), input resolution and aspect ratio; for example:

 

 

Input

Current Source

Format

Resolution

4.1

Turning on the Power

Component SD NTSC

480i

AnamorphicVivixCi

Aspect

Ratio

By default, the VX-4000d/VX-5000d is configured for a “floor/front” installation, in which the projector is installed upright and in front of the screen. If it is installed behind the screen and/or mounted on a ceiling, you must change the picture orientation. To do this:

1.Press MENU (on menu page 4) and enter the Service Menu passcode.

2.Select Service from the Main Menu.

3.Select Display Device from the Service Menu, then select Configure.

4.Press , then choose Floor/Rear, Ceiling/Front or Ceiling/Rear, to match the installation method.

You must enter a passcode to access the Service menu.

Note

4.2

Adjusting the Picture Orientation

By default, the VX-4000d/VX-5000d is configured to display the signal received on its RGBHV input. To use the DVI input instead:

1.Press MENU (on menu page 4) and enter the Service Menu passcode, if the Service Menu is not already visible.

2.Select Service from the Main Menu.

3.Select Display Device from the Service Menu, then select Configure.

4.Input 1 is the RGBHV input. Press to select projector input 2 (DVI).

4.3

Selecting the Input Source

Runco VX-4000d/VX-5000d Owner’s Operating Manual

37

Page 49
Image 49
Runco VX-5000d, VX-4000d Operation, Turning on the Power, Adjusting the Picture Orientation, Selecting the Input Source