Speaker Installation, Finally | Russound CA-Series instruction

SPEAKER INSTALLATION

•If you are installing in-wall speakers, follow the instruc- tions provided with your speakers for mounting.

•Make sure that the voltage selector, located on the rear panel of the CA, is on the correct current for your country, either 110V or 220V

•Power up by plugging in all power cords and turning the CA and sources on.

Image 11

Contents

CA-Series Important Safeguards Contents Unpacking Possible System ConfigurationsProduct Overview Feet Getting StartedTools Needed Connection Tips List 1 Source names should be written below Rear Panel ConnectionsSpeaker Connections Volt Trigger Output IR Remodulator 56K Included AccessoryConnecting the IR Link Zone PRE-AMP Outputs CA4.4PI only Keypad Connections AT Controller Wiring Runs UP to 100 Feet Punchdown Terminals Installing KeypadsInstalling the Keypads Repeat the above steps until all keypads are installed SRM-2.1 Speaker Relay Module Option Setting the KeypadsSource Control Keypads Option Finally Speaker InstallationSpeaker Installation Connect each speaker wire to the correct polarity + Operating the CA KP.2 Keypad OperationOperating the Main Unit Store PowerOperating the CA-LCD Keypad Lamp Elimination of Balance Line SpecificationsTroubleshooting Keypad Wiring Protection Circuit Combining Additional IR Receivers Warranty 28-1116 R6