Russound CA-Series instruction manual Operation, Operating The Ca-Lcdkeypad

OPERATING THE CA-LCD KEYPAD

1)Display: The LCD panel displays the name of the source selected and the volume level.

2)Source: The source button is pressed to select one of the four sources to listen to. Press the source button until the desired source is selected. The source will be displayed on the LCD display panel.

3)Volume Up / Down: The UP / DOWN arrows for volume are used to select the volume level and to select a differ- ent source name after the store button is pressed. If the button is pressed and held the volume will ramp up or down.

4)Lamp: The lamp button when pressed and released will turn on and off the backlight lamp. The backlight color can be set to amber or green by pressing and holding the button. The backlight will change from one color to the other.

5)Power: Turn on or off any zone by pressing the power button on the front of the corresponding keypad. When the keypad comes on, it will automatically select the source that was previously selected and set the volume to minimum.

6)Store: The store function is used to select and store one of the 23 preset source names for each of the four sources. Select the source name that you want to change by selecting source. Press and hold the store button for approximately 3 seconds, and the display begins to flash. Immediately press the UP/ DOWN volume buttons to select the different source names. After you have selected the name, press the store button again or wait for it to stop flashing.

7)IR Receiver: The IR receiver is used to receive commands from an IR remote control. Remote controls used for the source equipment will pass through to the main con- troller and on to the source equipment. It will receive IR signals from 38KHz to 56KHz. To control the functions of the CA-LCD keypad, use the CA Remote control (see Figure 6). The CA remote control will operate the lamp, source selection, volume up / down and room on / off.

8)IR Confirmation LED: This LED will flash to confirm the reception of an IR signal from a remote control through the IR receiver.

OPERATION

Figure 18 - CA-LCD Keypad Functions

		1-Display
		2-Source
		3-Volume Up / Down
		4-Lamp
	VOLUME	5-Power
SOURCE
	STORE POWER	6-Store
	REMOTE SENSOR	7-IR Receiver
		8-IR Confirmation LED

Figure 19 - CA-LCD RC Remote Control Functions

ON ROOM OFF

1 2

LISTEN TO

3 SOURCE 4

VOLUME

VOLUME

SOURCE

CA LCD RC

STORE POWER

REMOTE SENSOR

13