Russound PR-4Zi instruction manual Peripheral Devices, Operating The Dsc/Dan Keypads

Peripheral Devices

DSC/DAN KEYPADS

Once the PCK(IR) keypads have been wired, con- nect the DSC keypad’s 16-pin header to the 16- pin receptacle on the side of the main keypad (see Figure 1a and 1b). Be sure to keep the cor- rect pin alignment. If you are using a DAN key- pad with the system, connect it to the input receptacle on the side of the DSC keypad.

Figure 13 – DSC and DAN docking
PCK-IR OR PCK				DSC				DAN
BASS	TREBLE	VOLUME
				SEEK
	SELECT			MODE			1	2	3
TUNER	CD	TAPE	PRG	SELECT		PRG	4	5	6
VID1	VID2	DVD	CLR	SCAN		CLR	7	8	9
					IR					IR
LOUD	ON/OFF	PRESET	RST		IN PRG	RST		0	ENTER	IN PRG
	ZONE
SYSTEM		SYSTEM			STO					STO
					ERR					ERR
ON		OFF
PR-4Z SYSTEM CONTROLLER				DIRECT SOURCE CONTROL				DIRECT ACCESS
							NUMERIC SOURCE KEYPAD

OPERATING THE DSC/DAN KEYPADS

1Select the source that you wish to control on the main keypad (this will also select the source for listening).

2Press the command key(s) on the DSC or DAN which have been programmed with the commands that you wish to execute.

3The Program indicator will flash as the command is outputted. If the Program indicator does not flash when the command key is pressed, the command was not stored properly.

14