Russound PR-4Zi instruction manual IR Emitters, Source-specific IR outputs Figure

Peripheral Devices

IR EMITTERS

The PR-4Zi has seven IR outputs: Source 1–6 and Common. Source 1–6 outputs are source-specific and provide IR signals only to the selected source; the Common out- put provides IR signals to all sources.

Source-specific IR outputs (Figure

17)are useful when a system has two or more of the same model source component, allowing you to target the IR commands to each individual component.

Figure 17 – Source-specific infrared outputs

845.1MICRO EMITTERS TO IR RECEIVER WINDOW

OF SOURCE EQUIPMENT

SOURCE 2

To connect multiple emitters to the Common IR output, use the Russound 857 connecting block and a 1/8-inch (3.5mm), 2-conduc- tor (mono) phone plug as shown in Figure 18. Connect common (COM) IR output to “IR INPUT” on the 857 connecting block.

SOURCE 1

Figure 18 – Common infrared output

TIP

SLEEVE

1/8" (MONO)

PHONE PLUG

STRIPE WIRE

IS SIGNAL

(WIRES TO TIP)

DESIGNED	SIGNAL	STATUS	GND	+12VDC	IR C IOMMONN	IR R IECEIVERN	POWER +12VDC	STATUS +12VDC	RUSSOUND #857
									CONNECTING BLOCK
IN USA
MADEIN					ONFIRMC IR		LOCK ONNECTING
							B	C
							NFRAREDI 857
KOREA					SMITTER E
		6		5	4	3	2	1

RUSSOUND #845.1 MICRO EMITTERS

TO IR CONTROLLED EQUIPMENT

17