ST2 TUNER PROGRAMMING
ST2 TUNER SETUP MENU
Source Number
The Source Number procedure provides Tuner 1 and Tuner 2 with the proper source identities pre- viously assigned in the CAV6.6 setup. The CAV6.6 source setup procedure must be com- pleted before performing this step.
1.Enter the Setup Menu by pressing and holding the TNR SEL button.
2.Press MEM Up/Down until SOURCE NUM appears on the tuner.
3.Press BAND.
4.Press the Tune Up/Down buttons to select the Tuner #.
5.Press BAND. SOURCE NUM appears again.
6.Press the Tune Up/Down buttons to scroll through the source numbers
5.Press BAND to select the source number (as
determined in the CAV6.6 setup process).
6.Repeat the process for the next tuner.
7.Press TNR SEL to exit the Source Number menu.
NOTE: Once the programming procedures are completed, cycle the power to the Tuner to establish a connection with the CAV6.6.
Region
The Region procedure assigns either US or Euro to the tuner. The difference between the two is that US FM frequencies operate in .2 MHz incre- ments, while European FM frequencies operate in
.05 MHz increments.
(Continued on next page)
Press and Hold TNR SEL button
TNR TNR
SEL SEL
Source Number, Region, Factory Initialization, Update Firmware and System Info Procedures
MEM | BANK | SOURCE | REGION | FACTORY | UPDATE | SYSTEM | Setup | |
NAME | NAME | NUM | INIT | FIRMW | INFO | |||
Procedure | Menu | |||||||
Procedure | Procedure | Procedure | Procedure | Procedure | Procedure | |||
| ||||||||
|
| TNR |
|
|
|
|
| |
|
| SEL |
|
|
|
|
| |
|
| TUNER |
|
| HOLD |
|
| |
|
|
| This | BAND |
|
| ||
|
| # |
|
|
| |||
|
|
|
|
|
| |||
|
|
|
| Procedure |
|
|
| |
|
|
|
| returns the |
|
|
| |
|
|
|
| ST2 Tuner |
|
|
| |
|
|
|
| to its |
|
|
| |
|
|
|
| Factory | After update |
|
| |
|
|
|
| settings | cycle Power |
|
| |
|
| SOURCE |
|
|
|
|
| |
|
| NUM |
|
|
|
|
| |
|
|
|
|
| Start |
|
| |
|
|
|
|
| Update |
|
|
Cycle Power
23