Russound ST2 Region continued, Factory Initialization, Update Firmware, System Info

ST2 TUNER PROGRAMMING

ST2 TUNER SETUP MENU

Region (continued)

1.Enter the Setup Menu by pressing and holding the TNR SEL button.

2.Press MEM Up/Down until REGION appears on the tuner.

3.Using the Tune Up/Down buttons, view the US and Euro selections.

4.Press BAND to select the region.

5.Press TNR SEL to exit the Region menu.

Factory Initialization

The Factory Initialization procedure allows the erasure of all programmed settings and returns them to the factory default settings.

1.Enter the Setup Menu by pressing and holding the TNR SEL button.

2.Press MEM Up/Down until FACTORY INIT appears on the tuner.

3.Press BAND to enter the FACTORY INIT menu.

4.“Are you sure” appears on the tuner. Using the Tune Up/Down buttons, view the “Yes” and “No” selections.

5.Press BAND to select. A “No” selection returns to the top of the Factory Init menu. A “Yes” begins the initial- ization.

6.“Please wait” appears on the tuner during the process and “Done” appears when complete.

7.Press TNR SEL to exit the Factory Init menu.

Update Firmware

The Update Firmware procedure allows the ST2 tuner’s OS firmware to be updated. The proce- dure is performed using a DB9 serial cable with one end connected to the RS-232 port on the back of the tuner and the other connected to a PC or laptop. If an OS firmware update is avail- able, it can be obtained through the Document Center at www.russound.com.

1.Enter the Setup Menu by pressing and holding the TNR SEL button.

2.Press MEM Up/Down until UPDATE FIRMW appears on the tuner.

3.Press BAND to enter the UPDATE FIRMW menu.

4.“Hold BAND” appears on the tuner.

5.While pressing and holding BAND, “After

update cycle power” appears on the tuner dis- play.

6.When “Start Update” appears on the tuner dis- play, start the update program. “Finished” appears on the computer screen when complete.

7.Cycle power to the tuner.

System Info

The System Info menu shows the ST2 Tuner’s manufacturing build properties.

1.Enter the Setup Menu by pressing and holding the TNR SEL button.

2.Press MEM Up/Down until SYSTEM INFO appears on the tuner.

3.Press BAND.

4.Press BAND at “Build Time” to view.

5.Press MEM Up/Down to advance.

6.Press BAND at “Build Date” to view.

7.Press MEM Up/Down to advance.

8.Press BAND at “Version” to view.

9.Press TNR SEL to exit the System Info menu.

Restore and Backup

Once all of the tuner settings are completed, it may be advisable to create a backup of the pro- grammed settings for future use. The backup will then be available in case tuner settings need to be restored.The backup and restore PC applica- tion is available through the Document Center at www.russound.com. Also required are a DB9 male-to-female cable and laptop or desktop PC.

24