ASSEMBLY
MAKING INSERT PLATE LEVEL
See Figure 12.
Unplug the router table and/or the router.
Check to see if the insert plate mounted assembly is level with a straight edge or level.
Using the supplied hex key, tighten or loosen the adjust- ing screws depending on how the insert plate needs to be adjusted in order to make the insert plate level.
Tighten insert plate screws with a screwdriver.
HEX KEY
INSERT
PLATEADJUSTING
STRAIGHT SCREWS EDGE
3
2
1 
0 
1
Inch
ATTACHING THE FENCE ASSEMBLY
See Figure 13.
Unplug the router table and/or the router.
Place the router table right side up with the back edge 
closest to you.
FEED DIRECTION
3
2
1 
0 
1
Inch
Slide the carriage bolt washers onto the carriage bolts.
Slide carriage bolts through the slot in the router table and through the slots in the fence assembly.
Slide the fence lock knob washer over the carriage bolts.
Install the fence lock knobs over the carriage bolts. Tighten the fence lock knobs.
WARNING: |
|
Make sure throat plates snap securely into place. Do | SLOT |
not use if snaps are damaged or throat plates do not |
|
snap in securely. Failure to do so could result in serious |
|
personal injury. |
|
| Fig. 12 |
FENCE LOCK KNOB | FENCE LOCK KNOBS |
WASHER |
|
Inch
1
1 
2 3
INSERTING AND REMOVING THROAT PLATES
See Figure 14.
The throat plate provides a stable surface around the cutter and prevents objects from falling through the throat plate and damaging the spindle.
CARRIAGE BOLT 
WASHER
CARRIAGE BOLTS
Inch
1
FENCE
ASSEMBLY
Fig. 13
14
