ASSEMBLY
The proper size throat plate depends on the size and shape of the cutter. When inserted, the throat plate opening should be within approximately 1/4 in. of the outermost edge of the cutter.
Unplug the router table and/or the router.
Select the throat plate you wish to use.
Press throat plate into insert plate slot until it snaps into place.
To remove, push throat plate out from the bottom of the insert plate.
THROAT PLATE
TAB
2
1 
0 
1
INSERTING THE STARTING PIN |
|
See Figure 15. |
|
Place the starting pin on the router table and use it as a pivot |
|
point when cutting small, | NOTCH |
NOTE: It is not necessary to use the fence when you are
using the starting pin, but the bit guard should be used to 
cover the cutter. Additionally, only use piloted cutters when
using the starting pin.
Unplug the router table and/or the router.
Place the starting pin into the hole to the right of the router | 1 |
table throat opening. |
|
2
1 
0 
1
Fig. 14
STARTING PIN
Push the pin in to secure.
INSTALLING THE MITER GAUGE
See Figure 16.
Unplug the router table and/or the router.
With the router table right side up, and the front edge closest to you, place the miter gauge bar in the slot near the front of the table with the pointer on the right.
STARTING
PIN HOLES
INSTALL
REMOVE 
0 
1
Inch
Fig. 15
MITER |
|
GAUGE BAR | MITER GAUGE |
POINTER
FEED DIRECTION
0 
1 
Inch
SLOT
Fig. 16
15
