OPERATION
TO USE OUTFEED SUPPORT
See Figure 24.
OUTFEED
The outfeed support slides to give the operator additional SUPPORT support for cutting long workpieces.
With the table saw in the off position, stand behind the
saw.
Grasp the outfeed support with both hands and pull the outfeed support until it is fully extended.
TO USE SOLID TABLE EXTENSION
See Figure 25.
The solid table extension provides the operator with a flat surface.
Remove the sliding miter table by turning the table lock
knobs counterclockwise. |
|
Place the solid table extension in the slot. |
|
Retighten the table lock knobs. | Fig. 24 |
WARNING: | TABLE |
Never stand directly in line with the blade or allow hands | LOCK |
KNOBS | |
to come closer than 3 in. to the blade. Do not reach over |
|
or across the blade. Failure to heed this warning can |
|
result in serious personal injury. |
|
MAKING CUTS
The blade provided with your saw is a
WARNING:
All blades must be rated for at least 5,500 RPM to prevent possible injury.
TO MAKE A CROSS CUT
See Figure 26. | Fig. 25 |
WARNING:
Never use rip fence as cutoff gauge when crosscutting.
WARNING:
Make sure the blade guard assembly is installed and working properly to avoid serious personal injury.
Note: When the miter fence is placed in the first hole (one towards the center of the sliding miter table), use the scale on the outside of the sliding miter table. To increase cutting capacity, use the second hole (one closest to the front of the table), using the front of the miter fence to read the inner scale.
It is recommended you make test cuts on scrap wood.
Remove the rip fence by lifting the locking handle.
Set the blade to the correct depth for the workpiece.
Page 23
MITER
FENCE
Fig. 26
