TROUBLESHOOTING

IF THESE SOLUTIONS DO NOT SOLVE THE PROBLEM CONTACT YOUR AUTHORIZED SERVICE DEALER.

PROBLEM

POSSIBLE CAUSE

SOLUTION

Engine will not start

No spark.

Clean or replace spark plug. Reset spark plug gap.

 

 

Refer to Spark Plug Replacement earlier in this

 

 

manual.

 

No fuel.

Push primer bulb until bulb is full of fuel. If bulb does

 

 

not fill, primary fuel delivery system is blocked. Con-

 

 

tact a service dealer. If primer bulb fills, engine may

 

 

be flooded, proceed to next item.

 

 

Set the start lever to the START position. Squeeze the

 

Engine is flooded.

trigger and pull the rope repeatedly until the engine

 

 

starts and runs.

 

 

NOTE: Depending on the severity of the flooding, this

 

 

may require numerous pulls of the rope.

 

 

 

Engine does not reach full

Air filter screen is dirty.

Clean air filter screen. Refer to Cleaning Air Filter

speed and emits excessive

 

Screen earlier in this manual.

smoke

 

Contact a servicing dealer.

 

 

 

Spark arrestor screen is dirty.

Clean or replace spark plug. Reset spark plug gap.

 

 

 

Spark plug fouled.

Refer to Spark Plug Replacement earlier in this

 

 

manual.

 

 

 

Engine starts, runs, and accel-

Idle speed screw on carburetor

Turn idle speed screw clockwise to increase idle

erates but will not idle

needs adjustment.

speed. See Figure 28.

 

 

 

Engine emits too much smoke

Too much oil in crankcase.

Drain lubricant and refill with correct amount of 10W-

 

 

30 engine lubricant. See Adding/Checking Engine

 

 

Lubricant in the Operation section of this manual.

 

 

 

Engine rope cannot be pulled

Oil has entered the combustion

This is usually caused by storing the unit for an extended

 

chamber.

time with the engine in an upside-down position. Remove

 

 

and clean the spark plug. Drain the oil out of the spark

 

 

plug hole, then reinstall the spark plug.

 

 

Check engine lubricant and add if necessary prior to

 

 

starting. Refer to Adding/Checking Engine Lubri-

 

 

cant earlier in this manual.

 

 

 

Line will not advance

Line is welded to itself.

Replace line. Refer to the applicable line replacement

 

 

section in this manual.

 

Not enough line on spool.

Install more line. Refer to the applicable line replace-

 

 

ment section in this manual.

 

 

Pull lines while alternately pressing down on and

 

Line is worn too short.

releasing spool retainer.

 

 

Remove line from spool and rewind. Refer to the ap-

 

Line is tangled on spool.

plicable line replacement section in this manual.

 

 

Advance line at full throttle.

 

Engine speed is too slow.

 

 

 

 

14 — English

Page 18
Image 18
Ryobi C430 RY34421, S430 RY34441 manuel dutilisation Troubleshooting, Problem Possible Cause Solution, Speed. See Figure