Ryobi DP102L manual CHECKING/ADJUSTING Laser Alignment, Laser Housing, Laser Adjustment Knob

ASSEMBLY

CHECKING/ADJUSTING LASER ALIGNMENT

See Figure 15.

Check the laser alignment to ensure the intersection of the laser lines is precisely at the spot where the drill bit meets the workpiece. If it is not, the laser lines should be adjusted using the laser adjustment knobs located on opposite sides of the head assembly.

nMark an “X” on a piece of scrap wood.

nInsert a small drill bit into the chuck and align its tip to the intersection of the lines of the “X”.

nSecure the board to the table.

nTurn on the laser and verify the laser lines align with the “X” on the workpiece.

nIf the laser lines do not align, loosen the set screws on each of the laser housings with a hex key and rotate the laser adjustment knobs until the lines meet in the center of the “X”. Retighten the set screws to secure.

LASER HOUSING

SET SCREW

LASER

ADJUSTMENT

KNOB

Fig. 15

17